arcsoft photostudio 5.5 vs arcsoft photostudio 6

#Arcsoft photostudio 5.5 vs arcsoft photostudio 6 driver#

Selecting Flexible enlarges 35 mm film to the Photo Size (4'圆').If 'Image display (150dpi)' is selected in step 9 If 'Print (300dpi)' is selected in step 9 You can select from the following options. More than one frame cannot be selected (blue selection frame) at the same time. The Output Size options in the next step will vary according to the Destination setting selected. Select a frame (click it and the blue selection frame displays) and a Destination setting: either Print (300 dpi) or Image display (150 dpi). If you do not need to scan a frame, click the check mark to remove it. Place a check mark beside the frames you wish to scan.Ī check mark automatically appears on the first frame.Do not open the document cover while a scan is in progress.If the previewed image does not display correctly, adjust the position of the film in the Film Guide and click the button again.Negative Film (Color) / Positive Film (Color)

You can select from the following options:

If ScanGear CS is in the Advanced Mode, click the tab to display the Simple Mode window.

Double-click the alias on the desktop or open the folder, and double-click the folder, followed by the icon.

Click the menu and select, followed by and.

Start ScanGear CS from within the application program. Refer to the Quick Start Guide for positioning film.

Set the film in the Film Guide, and position the Film Guide on the document glass of the scanner.

Remove the protective sheet from the document cover of the scanner.

In the Simple Mode, there are only a few simple procedures. To scan 35 mm film strips and slides into an application program, you can start ScanGear CS from within the program. Scanning Films with ScanGear CS in Simple Mode Including a portion of the film base or the Film Holder in the scan may cause the coloration of the scanned image to be off.

If a portion of the film base outside the image or the Film Guide shows in the preview image, select a scan area with the cropping frame before scanning. Moreover, it may not show when a single frame is scanned. The time shown is a rough estimate that will vary according to the computer system environment and scan settings. The estimated time remaining will display when multiple frames are scanned. Mounted 120 format films cannot be scanned.ĭo not set positive and negative films in the same Film Guide. See Scanning Films with ScanGear CS in Advanced Mode To scan monochrome films, mounted negative slides and 120 format films, start ScanGear CS from an application program and use the Advanced Mode to scan. Monochrome films, mounted negative slides and 120 format films cannot be scanned with these methods. Only 35 mm color film strips and mounted positive slides can be scanned with the scanner buttons or CanoScan Toolbox.

#Arcsoft photostudio 5.5 vs arcsoft photostudio 6 driver#

This method summons the ScanGear CS driver window from an application program and scans 35 mm film strips, slides, and 120 format films in Advanced Mode, allowing you to adjust various settings. Scanning Films with ScanGear CS in Advanced Mode This method summons the ScanGear CS driver window from an application program and scans 35 mm film strips and slides in Simple Mode, allowing you to adjust a few settings. This scanner can scan 35 mm film strips up to 12 frames, 35 mm mounted slides and 120 format films. Scanning Films with ScanGear CS in Advanced Mode.Scanning Films with ScanGear CS in Simple Mode.